Super Eyes project showcases an advanced integration of multiple smart systems aimed at enhancing safety, sustainability, and convenience in modern living environments. It combines a Savior Bike, a Compact House with rainwater harvesting, a Benefit Home, and a Smart Light System, Super Eyes project for students
Super Eyes project integrates multiple smart systems to enhance safety, sustainability, and convenience, addressing the challenges posed by overpopulation. It combines a Saviour Bike, a Compact House with rainwater harvesting, a Benefit Home, and a Smart Light System. This comprehensive solution aims to promote efficient living and resource management in modern environments, Super Eyes project for school students.
Components Required
- Arduino Uno
- NodeMCU (ESP8266)
- Servo Motor (360-degree continuous rotation)
- 2 LEDs
- 2 Resistors (220 ohms)
- Jumper wires
- Breadboard
Circuit Connection
Arduino Uno:
- Servo Motor:
- Signal pin to Arduino digital pin 9.
- Power (VCC) and ground (GND) to Arduino’s 5V and GND pins.
NodeMCU:
- LEDs:
- LED1: Anode to NodeMCU pin D1, cathode to ground via 220-ohm resistor.
- LED2: Anode to NodeMCU pin D2, cathode to ground via 220-ohm resistor.
Circuit Diagram is given below:
